Running a sump pump from a power station

Pinned models: EcoFlow DELTA 3 Plus (US), Jackery Explorer 1000 v2 (US), Anker SOLIX C1000 (US), EcoFlow DELTA Pro 3 (US), Anker SOLIX F3800 Plus (US) · Last checked 2026-10-25

Affiliate links. Disclosure

Checked: 2026-10-25.

Yes, if the station's surge rating covers the pump's starting watts and its continuous rating covers the running watts. Take both figures from your pump's manual or label; there is no official generic start-up multiplier.

A plug-in pump can go straight into the station. A hard-wired pump needs a transfer switch or inlet installed by a licensed electrician; see transfer switch basics.

Pinned models

Station limits

StationContinuous ACSurgeCapacity
EcoFlow DELTA 3 Plus1800 W3600 W1024 Wh
Jackery Explorer 1000 v21500 W3000 W1070 Wh
Anker SOLIX C10001800 W2400 W (SurgePad limit, not a motor-start rating)1056 Wh
EcoFlow DELTA Pro 34000 W8000 W4096 Wh
Anker SOLIX F3800 Plus6000 WNot published as a single figure3,840 Wh

Worked runtime

A sump pump runs in cycles, so energy depends on how often it switches on. Example only: a pump whose manual lists 800 W running, cycling for a total of 2 hours a day, uses 800 × 2 = 1,600 Wh per day. That is more than a ~1 kWh station holds, and about 2.5 days on a DELTA Pro 3 (4096 ÷ 1,600) before losses.

Use your pump's watts and your own estimate of run time; in heavy rain it can run far more. Our sizing guide explains the margin to add. For long storms, compare with a generator in generator vs power station.

Affiliate placeholder: EcoFlow via Impact (no program active, no link) Affiliate placeholder: Jackery via Impact (no program active, no link) Affiliate placeholder: Anker SOLIX via Impact (no program active, no link)

Sources